Skip Navigation Website Accessibility
 

STATLER MOD 3 thru F, Y SIGNAL CABLE

   
Quantity:    

Add to Cart
Statler Cable for the Mod 3 and Mod E  and Mod F Systems Only.  This one is the Y Signal cable, use in the case of errors where the patterns are being distorted in their height possible because the Y motor is not getting power or not responding properly.  Consider getting an entire set of cables - they are all the same age and it may be advantageous to just change them all at the same time.  We start thinking about the age of the cables at about 10-12 years, depending on the amount of use the machine has had.   There are only so many millions of times you can bend a wire before it breaks. This part needs to be soldered into place.  The machine will have to come off the cross-track so that the crosstrack can be flipped over to access the wiring.  This is generally considered a job for a Gammill tech to perform.

Contact Info
  • Primary Location
  • 118 E 4th Avenue
    Ellensburg, WA 98926
  • Phone: (509) 607-3951
  • Sales Representatives
    Contact a Sales Representative to try a Gammill machine near you!
Get Directions